Nut slots

Logically, the nut slots should need no more clearance above the first fret than would otherwise be required between the first and second,

Nut slots Sometimes that $3 piece of bone blank IS worth investing $70 to have a luthier perform fit & finish ! John Nut slot depth?-nut_file-jpg 08

Logically, the nut slots should need no more clearance above the first fret than would otherwise be required between the first and second,

rich wilde and the shield of athena slot soldi veri The nuts are cut to generic specs Depending on the string gauge you are using, it's very likely that the nut slots are a bit off This is part

There is about 1mm at the nut between bottom of the low E string and the fret board The Murphy's nut slots are not as deep Much more of the

nut slot height Nut slots need care and attention to detail I do it by feel, by doing it very slowly, and a little at a time If the slots become too deep,

The trick is getting the nut slots to the proper depths Some simply sand the bottom on pre-slotted nuts ( I do this myself to get the nut to a